Results 1 to 3 of 3

Thread: Harmonic Balancer

  1. #1

    Harmonic Balancer

    GM I have a 96 International 4900 DT466E engine. I am trying to get the harmonic balancer off. I took the 3 bolts out from the center of it but I cannot get the plate for those bolts out to gain access to the crank. Is there a trick to get that center plate out so I can gain access?

  2. #2
    Senior Member
    Join Date
    Dec 2015
    Location
    washington, st.
    Posts
    796
    You know I'm not sure but I think that plate is part of the balancer. Have you tried removing the balancer as it is right now?

    Truck Shop

  3. #3
    That plate does indeed come out, they usually have rtv sealing/sticking them in there, pointy bar or long bolt, wiggling and patience.

    Those dampers are an interference fit on the crank snout, must be heated internally to a certain temp (can't remember how hot) to install, I used an electric cattle dehorner that fit inside the damper and of course a temp gun.
    Last edited by mobilemech; 06-20-2017 at 11:12 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •